SG Connect - Add sensors

Purpose
To control a group or a zone with one sensor, external ZGP-sensors can be commissioned to a group or to a zone, consisting of lights with wireless drivers.

How to – add a sensor

  • Click on the “+” on the group screen and select “Sensors”.

  • From the drop-down list of available sensors, select the type of sensor you like to add.

  • Next indicate whether you would like to add the sensor to a zone or to the whole group.

  • Follow the instructions for setting up the sensor.

  • When the sensor is added, you can choose to finish the process or assign lights to a daylight area.

Step-by-step guide

5.2.1.jpg
5.2.2.jpg
5.2.3.jpg
5.2.4.jpg
5.2.5.jpg
5.2.6.jpg
5.2.7.jpg

Remarks:

  • You can add more than one sensor to a group or zone.

  • You cannot add ZGP sensors to groups consisting out of slave drivers and sensors (hybrid networks). This will be enabled with a future app update.

  • In case ZGP-sensors are used for a group, and at the same time for zones of that group, the sensor(s) of the group must be added first.

  • With firmware 2.1.1, situations may occur when sensors cannot be added to the same group it was previously removed from. Try using a different sensor or to recommission the entire group.

How to - removing am external ZGP-sensor.

  • A sensor can be removed by following the steps below.

  • When you remove a sensor, you must remove all sensors and switches in the group/zone. Additionally, you must reset the sensor if you want to reuse it.

Go to top

Add daylight area

Purpose
Lights assigned to a daylight area, dim down when the amount of daylight as sensed by internal sensor, increases. You can assign daylight areas to a group and/or to a zone. Only the lights in the daylight area will follow daylight regulation. Typically, those are the lights close to the window.

How to

  • Choose “Create daylight area” at the end of the sensor commissioning or via the device info screen of the sensor from the group overview.

  • Assign a name for the daylight area.

  • Select devices for the daylight area and click next.

  • Choose “Calibrate and turn on” to activate the calibration process. This process can be skipped by selecting “Calibrate later” and done via the device info screen from the group overview.

  • After the calibration is done, hit “Finish” to finalize the commissioning.

Step-by-step guide

5.3.1.jpg
5.3.2.jpg
5.3.3.jpg
5.3.4.jpg
5.3.5.jpg
5.3.6.jpg
5.3.7.jpg
5.3.8.jpg
5.3.9.jpg

Remarks:

  • A daylight area can be in a group or in a zone but cannot include lights of different zones, or lights of a zone and lights outside that zone.

  • Up to 25 lights can be moved into a daylight area.

  • For best lighting performance, it is recommended to calibrate daylight areas with blinds all the way down or at nighttime.

  • Lights can be moved from one daylight area to another and can be added or removed. But repeated actions can cause wrong light behavior. It is recommended to plan daylight areas carefully in advance.

Go to top

<-- Add switches

Menu

Configuration - Groups -->

You control your data

We use cookies on this site to enhance your user experience. Read about our Cookies and Privacy and Data Protection Policy. Find links in footer at the bottom at the page

You can withdraw your consent at any time by tapping the small icon in the bottom left corner of the website