SG Connect - Add luminaires - Flashlight

Purpose
Lights with an integrated sensor can be added to a group by pointing to them with a torchlight.

How to

  • Open the group, tap “+” and select “Lights” to start discovering all the SG Connect fixtures within Bluetooth range.

  • Please wait 10 seconds for the lights to be discovered.

  • Direct the light of a torchlight to the integrated sensor of the fixture that you like to add to a group for a couple of seconds.

  • The smartphone responds to the detection with a sound and a brief vibration. On the 2nd beep, the selected light dims down and shows up in the “Added” tap in the app. The light is now commissioned. Wait for another 3 seconds before proceeding to the next light.

  • When all luminaires for a group have been selected, choose “Finish adding”. The devices that are bind to that group are now displayed in the group overview.

Step-by-step guide

3A.1.jpg
3A.2.jpg
3A.3.jpg
3A.4.jpg
3A.5.jpg
3A.6.jpg
3A.7.jpg

Remarks

  • Use a torchlight with a well-defined light cone. Please refer to the design-in guide of the product for more information.

  • Typically, illuminance of the sensor should increase by ≥5000lx suddenly.

  • It is advised to wait for 2 beeps, after which a light will show up in “Added” tab.

  • In case a light is not added when torched, please re-try, or use the list-based commissioning.

  • In case a light can't be torched it might be that it was not in the scan list because of a too big range, e.g., in case of a long corridor. A re-scan of the lights with closer range is required to add this light to the list.

  • It is strongly recommended not to change the flashlight sensitivity in the app settings section.

<-- Create a group

Menu

Add luminaires - Blinking -->

You control your data

We use cookies on this site to enhance your user experience. Read about our Cookies and Privacy and Data Protection Policy. Find links in footer at the bottom at the page

You can withdraw your consent at any time by tapping the small icon in the bottom left corner of the website